DCC Concepts Cobalt Barrel-Plug Adapter (3 Pack)

Cobalt Barrel-Plug Adapter (3 Pack) Includes: A pack of three coaxial DC barrel plug adapters that will let you connect bare wires to a DC-plug fitted power supply that takes away the need to cut the plug off and get the soldering iron out. Suitable for the following DCCconcepts power supplies: - DCP-PS12 - DCP-12.3.XX - DCP-18.2.XX - DCP-18.5.XX

DCC Concepts Cobalt iP Digital Point Motor (Single)

Cobalt iP Digital Point Motor (Single) - Any Scale Includes: - 1x Digital Point motor - Instruction manual  - Product Size:   - Width 28.5mm (67mm over the mounting wings)   - Depth 40mm (48mm over the mounting wings)   - Height 44mm (67mm over the connector) - Bag of attachments Features: The Cobalt-iP Digital’s super-low static current draw means very low power bus loading and the Cobalt-iP Digital is also able to cope with a very wide range of DC or DCC power supply voltages. We prefer 9~12V regulated power for DC, but any DCC voltage from 7 to 23 volts is acceptable. Cobalt-iP Digital is supplied with the throw bar already centred for easy installation. You can activate and de-activate self-centring and even swap the throw direction with a simple software command. This allows easy matching to layout needs, software driven computer displays, track diagrams or computer control. With Cobalt-IP “Intelligent Power” Digital Motors, you also have all the connection versatility you could ever need already built in. Frog power needs only one added wire, and a totally separate SPDT changeover switch can facilitate interlocking, control of signal feather indicators or ground signals, etc. Cobalt iP Digital also features the ability to add panel switches or control via DCC. The connection terminals used for panel switch connection are also able to give direct high/low state computer or DCC system feedback, so one motor really CAN do it all. Add to the above the ability to work with DC and super-simple wiring or DCC operation, or to combine digital and analog control… and Cobalt iP Digital really is the best choice for all layouts, no matter how you choose to power the trains!

Gaugemaster Seep Point Motor with Built-In Switch

Seep Point Motor with Built-In Switch - Ideal for electrofrog points to change polarity at the same time as the tiebar - OO and N gauge

Peco Rail Cleaner - abrasive rubber block

Rail Cleaner - The abrasive block is rubbed along the top surface of the rails to clean any dirt that will stop/disturb electrical connection of your model locomotives/ accessories (thus leading to poor operation) - IMPORTANT not to press too hard on the track (always better to take a few passes with the rubber than in one go) - Always be gently around point work whilst cleaning otherwise you could damage the point blades and tie-bar (switch mechanism) 

Peco Microswitch enclosed type

Microswitch enclosed type - Designed to fit into O Gauge points in the tie-bar housing  - The switch is designed to operate the polarity of electrofrog point work