DCC Concepts Slim Vertical Mounted Magnetic Sensors (3-pack)

DCC Concepts - Slim Vertical Mounted Magnetic Sensors (3-pack) These detectors have been designed to be very easy to install. Super-slim at only 4mm in diameter, they will fit comfortably between the sleepers of DCCconcepts and Peco Code 100 and Code 75 track as well as most other brands of track in HO. (N scale users will need to temporarily move a sleeper while drilling, but will also find installation quite easy). They are Normally Off and are triggered or turned on by a small magnet that is attached to the loco or rolling stock. While it is always good to use smaller magnets and get the magnet as close as possible to any sensor such as this, we find that even with quite a small magnet we can get reliable results from up to 10mm away. Ideal for all detection and to trigger devices such as Cobalt Point Motors or Alpha. The connector is supplied so that the detectors can be used with our ADiA range of Accessory Decoders. Length of sensor: 15mm Width of sensor: 4mm Length of wire: 300mm Quantity in pack: 3 (Was DCP-TMS) Please note these are Normally Off or Normally Open momentary type connections

Peco Tracklayers Tool set

Tracklayers Tool set A specially selected tool set from expert modellers here at PECO for laying track. These tools are vital to all modellers, included also is expert knowledge in the form a useful guide brought to you by the experts at Railway Modeller. Includes: Xuron track cutters Snipe nose pliers Snap-off knife with 10 spare blades Set of 4 needle files Pin vice Drill bits: 0.5 to 2.5 mm A4 cutting mat Sharpie marker pen Track pin pusher PECO track pins PECO rail cleaner Shows you how guide: 'Laying the track'

Peco Track Isolating Switch

Track Isolating Switch - Place between two sections of track to isolate one from the other - Used on Analogue railways to park up more than one locomotive on a section of track (like in engine sheds, station bay platforms)

Peco Rail Cleaner - abrasive rubber block

Rail Cleaner - The abrasive block is rubbed along the top surface of the rails to clean any dirt that will stop/disturb electrical connection of your model locomotives/ accessories (thus leading to poor operation) - IMPORTANT not to press too hard on the track (always better to take a few passes with the rubber than in one go) - Always be gently around point work whilst cleaning otherwise you could damage the point blades and tie-bar (switch mechanism) 

Peco Power Feed Joiners For C100 - C124 Rail (4 pairs)

Power Feeds - Designed for Code 100 OO Gauge track including (Setrack and Code 124 O Gauge Tracks) - 4 Pairs included

Peco Power Feed Joiners For C55 - C80 Rail (4 pairs)

Power Feeds - Designed for Code 55 and 80 N Gauge Tracks - 4 Pairs

Peco Power Feed Joiners For C70 - C75 - C83Rail (4 pairs)

Power Feeds - Designed for Code 75 OO Gauge Track (Including Code 70 and Code 83) - 4 Pairs